Detection of aromatic compounds in tequila through the use of surface plasmon resonance.

For an expert nose, the aroma of a beverage is a fingerprint that can be used to certify its authenticity, distinguish between distillation processes, or even identify the raw material used to fabricate it. In this work, we propose a simple, automatic, and repeatable optical method, which can be used as a first and quick test to authenticate tequila samples. This method is based on the measurement of beam intensity changes, using the surface plasmon resonance technique, operating at a fixed angle. We observed that each tequila, depending on the alcohol content and aging process, produces a specific change in measured intensity level.

All-fiber processing of terahertz-bandwidth signals based on cascaded tapered fibers.

Tapered single-mode fibers are employed to perform dynamic pulse shaping in a bandwidth of several terahertz. The transfer function of cascaded biconical tapers is controlled by introducing a phase shift into one of them through mechanical stretching. It is a simple and low-cost technique with potential to process signals with bandwidths as large as those allocated by standard optical fiber while introducing little degradation. Femtosecond pulses are shaped to prove the concept.

Determination of quality and adulteration of tequila through the use of surface plasmon resonance.

In this work, the surface plasmon resonance (SPR) technique is used to determine the quality or adulteration of tequila beverages. Graphic analyses of the position and width of the SPR curve are related to the complex refractive index of the sample, showing differentiated regions where one can easily and unambiguously identify white, aged, or extra-aged tequilas, and even adulterated or low quality tequilas. The curves generated by aged and extra-aged tequilas, with respect to those obtained from white tequilas, are wider, while the resonant peak shifts towards larger angles. This behavior should be attributed to the aging process. The resonance curve is generated in 20 s, minimizing the variations of the SPR curve parameters due to temperature fluctuations.

Optical microfiber mode interferometer for temperature-independent refractometric sensing.

We report on a functional optical microfiber mode interferometer and its applications for absolute, temperature-insensitive refractive index sensing. A standard optical fiber was tapered down to 10 µm. The central part of the taper, i.e., the microfiber, is connected to the untapered regions with two identical abrupt transitions. The transmission spectrum of our device exhibited a sinusoidal pattern due to the beating between modes. In our interferometer the period of the pattern-an absolute parameter-depends strongly on the surrounding refractive index but it is insensitive to temperature changes. The period, hence the external index, can be accurately measured by taking the fast Fourier transform (FFT) of the detected interference pattern. The measuring refractive index range of the device here proposed goes from 1.33 to 1.428 and the maximum resolution is on the order of 3.7×10(-6).

Compact optical fiber curvature sensor based on concatenating two tapers.

A low-loss, compact, and highly sensitive optical fiber curvature sensor is presented. The device consists of two identical low-loss fused fiber tapers in tandem separated by a distance L. When the optical fiber is kept straight and fixed, no interference pattern appears in the transmitted spectrum. However, when the device is bent, the symmetry of the straight taper is lost and the first taper couples light into the cladding modes. In the second taper, a fraction of the total light guided by the cladding modes will be coupled back to the fundamental mode, producing an interference pattern in the transmitted spectrum. As the fiber device is bent, visibility of the interference fringes grows, reaching values close to 1. The dynamic range of the device can be tailored by the proper selection of taper diameter and separation between tapers. The effects of temperature and refractive index of the external medium on the response of the curvature sensor is also discussed.

Microstructured optical fiber coated with thin films for gas and chemical sensing.

We propose the use of tapered microstructured fibers with collapsed air-holes coated with thin layers for gas sensing. The collapsing of the holes allows having access to the evanescent fields which can be absorbed or attenuated with gas-permeable thin films. On the other hand, a section of the holey fiber is transformed into a solid multimode fiber. The beating between the multiple modes of the latter makes the transmission spectra of the device to exhibit an oscillatory pattern. This evanescent-fields-plus-modal-interferometer structure may offer interesting properties for gas and chemical sensing. As an example we demonstrate a hydrogen sensor.

Birefringence measurement in double-clad fiber lasers with large cross section.

We report on birefringence measurements in double-clad fibers with large cross section, doped with neodymium and ytterbium. The experimental results for rectangular double-clad fibers are compared with those for single-clad circular neodymium-doped fibers, taking into account existing models of stress- and geometry-induced birefringence. We demonstrated that the ellipticity of an outer silica cladding has no effect on birefringence in large-area double-clad fibers. The stress-induced birefringence is shown to depend on the ratio between the diameter of an internal silica support and the linear dimensions of the rectangular outer cladding. The stress-distribution pattern is derived to prove the experimental results.

Continuous-wave measurement of the fiber nonlinear refractive index.

We propose a technique for measuring the nonlinear refractive index of fiber based on transmission-coefficient measurements in a fiber Sagnac interferometer. In contrast with traditional methods, the proposed method uses a single optical source operating in cw mode and direct intensity measurement, enabling one to avoid the errors caused by fiber dispersion and uncertainty of spectral peak difference measurements that occur with pulse-based methods. The nonlinear refractive index in 20-mol. % GeO(2) fiber was measured to be (3.1 +/- 0.2) x 10(-16) cm(2) W(-1) at 1064 nm.